DNNNode Mounting Specifications
The DNNNode can begin to run quite hot when running AI applications due to the onboard GPU being at full utilization. For this reason, we recommend mounting the DNNNode using standoffs/spacers.
The threaded holes on the bottom of the DNNNode are compatible with 1/4" screws, so we recommend purchasing standoffs that will fit this screw size. The recommended standoff length is 20mm. An example of some standoffs
can be found here.
The hole pattern of the four mounting holes on the bottom of the DNNNode is shown in the diagram below (41.72mm, 1.643 in):
Related Articles
Node RTSP Stream Guide
This guide will walk through the steps required to port an RTSP stream into the DNNNode using BAI Core Services v3 and BAI Mobility Service. Formatting RTSP Stream URL As most IP cameras have login requirements for connections to the RTSP stream, you ...
Mast Arm Installation
DNNCam Mast Arm Installation Guide This guide will walk through properly mounting a DNNCam on a horizontal mast arm. Setup A proper DNNCam installation requires: - DNN-CAM-MNT - Mount Suitable for Mast Arm installation from Boulder AI. This includes ...
Node RTSP Stream Setup Guide v2
Node RTSP Stream Setup Guide This guide will walk through the steps required to port an RTSP stream into the DNNNode for data collection using the Web UI, the Data Acquisition service, and an AI application. 1. Formatting RTSP Stream URL As most IP ...
Firewall/Network Requirements
This article will discuss the firewall/network requirements for the software on a Boulder AI device to function properly. The following outbound sites/ports must be opened to allow a DNNCam or DNNNode to properly communicate with the Boulder AI ...